ᐅ Geeetech 3D-Touch Auto Bed Leveling Sensor – White

Preis: 28.15 22.7


Descriptions
Main Features Main Features:
● This is an auto leveling sensor for 3D printers based on open-source
● Simple, smart, high-precision, it could work with any kinds of bed materials, such as glasses, woods, metals and so on
● It can be operated in the following conditions: one I / O for control ( PWM or software PWM ), One I / O for Zmin( Z Probe ), GND and + 5V power

Cautions:
● Additional power supply will be needed in case your board does not supply enough amperage
● Electronic devices can be damaged or even destroyed if connected to wrongpolarity ( wrong terminal connect to 5V ( + ) and GND ( – ) )
● Pulling / pushing hard on the push-pin can damage 3DTouch and make it less accurate
● Fix push-pin with locking paint after reassembling or adjusting core
● Do not remove or deform elastic material attached on the push-pin Specification
Package Size ( L x W x H )
17.5*9.9*3.3CM
Package Weights
0.06KG
Packing Contents
Package Contents: 1 x Sensor, 1 x 3 Pin Straight Pin, 1 x 2 Pin Straight Pin, 2 x Screw Nut Washer, 2 x Dupont Housing Shell 3 Pin, 2 x Dupont Housing Shell 2 Pin, 10 x Dupont Terminal, 1 x 10KΩ 1 / 8W Resistor View More

Preis: 28.15 22.7